Burr walnut, zebrano or bird's-eye maple are among the most beautiful details of a classic car. After 30 or 40 years, however, they often show their age clearly. In this guide we explain how to tell that your wood trim needs restoring, how we go about it, what it costs and which mistakes you should avoid.
How to tell your wood trim needs restoring
The typical damage is almost always the same:
- Cracks in the clear coat – often fine lines across the part that become clearly visible over time.
- Clear coat lifting – usually at the corners and edges first.
- Faded wood – the wood looks pale, dull and flat.
- Whitish or yellowed lacquer – the parts no longer look fresh.
In most cases the cause is UV radiation. Over the years it hits the lacquer and the veneer underneath and bleaches both. Our restored parts on Instagram show how dark and rich burr walnut or zebrano can really be and how clearly the grain stands out – the difference to faded original parts is usually huge.
W124 centre console trims in burr walnut and zebrano after restoration
How a restoration works with us
- You send us your old parts. We work with your original parts so that fit and mountings are exactly right.
- The old clear coat is removed.
- The old veneer is removed.
- Sanding and repairs to the base material if needed.
- New real wood veneer is applied.
- New clear coat in 8 to 10 layers.
- Existing holes and cut-outs are milled out again.
- Final polishing and finishing.
What sets our work apart
- Real wood veneer only – no water transfer printing and no film.
- 100 % handmade in Europe.
- Colour matching with a reference part: To make sure restored parts don't differ from the rest of the interior, you can send along a part in good condition, for example a door trim. We use it to determine the colour and match the other parts to it.
What does a wood trim restoration cost?
The price depends on the vehicle and the scope – from a single console trim to a complete wood set. You can find all current prices in our wood restoration price list. For parts that are not listed, just send us a few photos and we'll give you an estimate.
For all restorations and custom work we invoice 50 % of the total at project start and the remaining 50 % on completion.
How long does it take?
For complete wood sets you should allow around 14 to 16 weeks, for a single console trim around 12 weeks. Each coat of lacquer needs about 24 hours to cure – quality can't be rushed here.
Frequently asked questions and misconceptions
Can you just repair the crack in the clear coat?
Unfortunately not. A crack in the clear coat is an opening: through this gap, UV radiation hits the veneer directly and the wood bleaches at exactly that spot. Even if you removed the old lacquer without damaging the veneer, which is only a few tenths of a millimetre thick – extremely difficult – the faded line would remain visible under the new lacquer. The crack would be gone, but its trace would not. A lasting solution is therefore only possible with new veneer.
Should I have all wood parts restored at once?
Not necessarily. If parts are far apart, such as the door trim and centre console trim on the W124, slight colour differences are hardly noticeable. It's different with parts that sit right next to each other or touch – for example the climate control panel, ashtray and console trim. Here we recommend restoring them together. Then not only the colour but also the grain matches 100 %.
Can I remove the clear coat myself to save money?
Please don't. We have seen several times that well-intended preparation does more harm than good: parts warp from too much heat, corners and edges break or get scratched, and no new veneer will hold on that. In the end it almost always becomes more work and more expensive. Better send us your parts as they are.
How to get started
Send us a few photos of your wood trim via our contact form or via WhatsApp to +49 162 9262645. We'll get back to you with an estimate and the next steps. If you'd rather buy new wood parts straight away, you'll also find ready-made parts in our shop. Related: Refurbish or replace your steering wheel?